ASTM D1830-99(2005)

    Standard Test Method for Thermal Endurance of Flexible Sheet Materials Used for Electrical Insulation by the Curved Electrode Method


      Format Pages Price  
    PDF 5 $60.00   ADD TO CART


    1. Scope

    1.1 This test method provides a procedure for evaluating thermal endurance of flexible sheet materials by determining dielectric breakdown voltage at room temperature after aging in air at selected elevated temperatures. Thermal endurance is expressed in terms of a temperature index.

    1.2 This test method is applicable to such solid electrical insulating materials as coated fabrics, dielectric films, composite laminates, and other materials where retention of flexibility after heat aging is of major importance (see Note 0).

    1.3 This test method is not intended for the evaluation of rigid laminate materials nor for the determination of thermal endurance of those materials which are not expected or required to retain flexibility in actual service.

    1.4 The values stated in acceptable metric units are to be regarded as the standard. The values in parentheses are for information only.

    1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazard statement, see .


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D149 Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials at Commercial Power Frequencies

    D374 Test Methods for Thickness of Solid Electrical Insulation (Metric) D0374_D0374M

    D5423 Specification for Forced-Convection Laboratory Ovens for Evaluation of Electrical Insulation

    IEC Publications

    IEC 216

    Institute of Electrical and Electronics Engineers Publications

    IEEE No. 101A Guide for the Statistical Analysis of Thermal Life Test Data (including Appendix A)

    IEEE No. 1 General Principles for Temperature Limits in the Rating of Electrical Equipment


    UNSPSC Code

    UNSPSC Code


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D1830-99R05

    Citation Format

    ASTM D1830-99(2005), Standard Test Method for Thermal Endurance of Flexible Sheet Materials Used for Electrical Insulation by the Curved Electrode Method, ASTM International, West Conshohocken, PA, 2005, www.astm.org

    Back to Top