ASTM D1817-01

    Standard Test Method for Rubber Chemicals—Density


      Format Pages Price  
    PDF 3 $52.00   ADD TO CART


    1. Scope

    1.1 This test method covers the determination of the density of solid chemicals used as rubber additives during processing and manufacture. It is intended for determining the density of the rubber chemical itself and not for the determination of the effective density of the chemical in a rubber.

    1.2 The values stated in SI units shall be regarded as standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    E1 Specification for ASTM Liquid-in-Glass Thermometers

    E300 Practice for Sampling Industrial Chemicals


    UNSPSC Code

    UNSPSC Code 13101607(Rubber compound)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D1817-01

    Citation Format

    ASTM D1817-01, Standard Test Method for Rubber Chemicals—Density, ASTM International, West Conshohocken, PA, 2001, www.astm.org

    Back to Top