SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|8||$60.00||  ADD TO CART|
1.1 This test method is used for evaluating the rust-preventive properties of metal preservatives under conditions of high humidity.
1.2 The values stated in SI units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Society of Automotive EngineersSAE 1009C Tee Reducer, Bulkhead on Side, Flareless Tube
A109/A109M Specification for Steel, Strip, Carbon (0.25 Maximum Percent), Cold-Rolled
D512 Test Methods for Chloride Ion In Water
D516 Test Method for Sulfate Ion in Water
E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves
E323 Specification for Perforated-Plate Sieves for Testing Purposes
Federal StandardsQQ-S-698 Steel Sheet and Strip, Low Carbon
Military StandardsMIL-C-15074E Corrosive Preventive Compound Finger Print Remover MIL-C-5646F Cloth, Airplane
ICS Number Code 75.100 (Lubricants, industrial oils and related products)
UNSPSC Code 12164501(Preservatives)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D1748-00, Standard Test Method for Rust Protection by Metal Preservatives in the Humidity Cabinet, ASTM International, West Conshohocken, PA, 2000, www.astm.orgBack to Top