ASTM D1743-94e1

    Standard Test Method for Determining Corrosion Preventive Properties of Lubricating Greases


      Format Pages Price  
    PDF 10 $60.00   ADD TO CART


    1. Scope

    1.1 This test method covers the determination of the corrosion preventive properties of greases using grease-lubricated tapered roller bearings stored under wet conditions. This test method is based on CRC Technique L 41that shows correlations between laboratory results and service for grease lubricated aircraft wheel bearings.

    1.2 The values stated in acceptable inch-pound units for the apparatus dimensions are to be regarded as standard, and the metric conversions are provided for information only. All other values stated in acceptable metric units are standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1193 Specification for Reagent Water

    D5969 Test Method for Corrosion-Preventive Properties of Lubricating Greases in Presence of Dilute Synthetic Sea Water Environments


    ICS Code

    ICS Number Code 75.100 (Lubricants, industrial oils and related products)

    UNSPSC Code

    UNSPSC Code 15121902(Grease)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D1743-94E01

    Citation Format

    ASTM D1743-94e1, Standard Test Method for Determining Corrosion Preventive Properties of Lubricating Greases, ASTM International, West Conshohocken, PA, 2001, www.astm.org

    Back to Top