SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|4||$52.00||  ADD TO CART|
1.1 This test method covers a procedure for collection of dustfall and its measurement. This test method is not appropriate for determination of the dustfall rate in small areas affected by specific sources. This test method describes determination of both water-soluble and insoluble particulate matter.
1.2 This test method is inappropriate for industrial hygiene use except where other more specific methods are also used.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B57 Specification for Copper-Alloy Condenser Tube Plates; Replaced by B 171
D1193 Specification for Reagent Water
D1356 Terminology Relating to Sampling and Analysis of Atmospheres
E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves
ICS Number Code 13.040.20 (Ambient atmospheres)
UNSPSC Code 77121501(Air quality management)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM D1739-98(2004), Standard Test Method for Collection and Measurement of Dustfall (Settleable Particulate Matter), ASTM International, West Conshohocken, PA, 2004, www.astm.orgBack to Top