Standard Historical Last Updated: Feb 19, 2014 Track Document
ASTM D1681-05

Standard Test Method for Synthetic Anionic Active Ingredient in Detergents by Cationic Titration Procedure

Standard Test Method for Synthetic Anionic Active Ingredient in Detergents by Cationic Titration Procedure D1681-05 ASTM|D1681-05|en-US Standard Test Method for Synthetic Anionic Active Ingredient in Detergents by Cationic Titration Procedure Standard new BOS Vol. 15.04 Committee D12
$ 75.00 In stock

Significance and Use

This test method determines anionic detergents commonly found in laundry, dishwashing, and other cleaning materials. Accurate determination of the anionic active substance is highly important in assessing the cost and effectiveness of such cleaning substances.

Scope

1.1 Direct titration of an anionic surfactant with a standardized cationic reagent is a simple and convenient method for the quantitative determination of the content of active ingredient. The end point is detffected by the transfer of a colored complex from an organic solvent phase to an aqueous phase. The relationship between anionic and cationic agents is not always stoichiometric, and for maximum accuracy the anionic type of interest should first be characterized and then used to standardize the cationic reagent. In most cases, however, the different anionic surfactants likely to be encountered react in the same proportions. That is, a cationic titrating solution standardized against a characterized anionic agent can be used to analyze other anionics of known molecular weights.

1.2 This test method is applicable to alkylaryl sulfonates and fatty alkyl sulfates. Low results are obtained with alkylbenzene sulfonates having the alkyl chain length less than eight carbon atoms. Low results are also obtained for alkyl sulfates with the alkyl chain length of less than twelve carbon atoms. The anionic surfactants characterized in accordance with Sections should be the sodium salt and not amine, ammonium, or potassium salts. In case only amine or ammonium salts are available, they should be first converted to the sodium salt before proceeding with this analysis.

1.3 The analytical procedures appear in the following order:

Sections
Separation of Alcohol-Soluble Matter8 and 9
Separation of Oil-Free Sulfonate10 and 11
Determination of Sodium Chloride (NaCl) Content12-17
Characterization of Anionic Surfactant Standard:
Part I. Determination of Surfactant, SO3 Content, and Solution Molarity18-20
Part II. Determination of Surfactant, SO3 and Active IngredientContents Combining Weight, and Solution Molarity21-24
Standardization of Cationic Reagent25-29
Quantitative Determination of Anionic Surfactant by Cationic Titration30-33

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific hazards statement, see Section .

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 15.04
Developed by Subcommittee: D12.12
Pages: 7
DOI: 10.1520/D1681-05
ICS Code: 71.100.40