ASTM D1640-95(1999)

    Standard Test Methods for Drying, Curing, or Film Formation of Organic Coatings at Room Temperature


      Format Pages Price  
    PDF 4 $52.00   ADD TO CART


    1. Scope

    1.1 These test methods cover the determination of the various stages and rates of film formation in the drying or curing of organic coatings normally used under conditions of ambient room temperature.

    1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D823 Practices for Producing Films of Uniform Thickness of Paint, Varnish, and Related Products on Test Panels

    D1005 Test Method for Measurement of Dry-Film Thickness of Organic Coatings Using Micrometers


    ICS Code

    ICS Number Code 87.040 (Paints and varnishes)

    UNSPSC Code

    UNSPSC Code 46181533(Protective coats)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D1640-95R99

    Citation Format

    ASTM D1640-95(1999), Standard Test Methods for Drying, Curing, or Film Formation of Organic Coatings at Room Temperature, ASTM International, West Conshohocken, PA, 1999, www.astm.org

    Back to Top