ASTM D1586-99

    Standard Test Method for Penetration Test and Split-Barrel Sampling of Soils


      Format Pages Price  
    PDF 5 $60.00   ADD TO CART

    Active (view current version of standard)

    Other Historical Standards

    Work Item(s) - proposed revisions of this standard

    ASTM License Agreement

    More D18.02 Standards Related Products


    1. Scope

    1.1 This test method describes the procedure, generally known as the Standard Penetration Test (SPT), for driving a split-barrel sampler to obtain a representative soil sample and a measure of the resistance of the soil to penetration of the sampler.

    1.2 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.> For a specific precautionary statement, see 5.4.1.

    1.3 The values stated in inch-pound units are to be regarded as the standard.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D653 Terminology Relating to Soil, Rock, and Contained Fluids

    D854 Test Methods for Specific Gravity of Soil Solids by Water Pycnometer

    D1587 Practice for Thin-Walled Tube Sampling of Fine-Grained Soils for Geotechnical Purposes

    D2216 Test Methods for Laboratory Determination of Water (Moisture) Content of Soil and Rock by Mass

    D2487 Practice for Classification of Soils for Engineering Purposes (Unified Soil Classification System)

    D2488 Practice for Description and Identification of Soils (Visual-Manual Procedure)

    D3550 Practice for Thick Wall, Ring-Lined, Split Barrel, Drive Sampling of Soils

    D3740 Practice for Minimum Requirements for Agencies Engaged in Testing and/or Inspection of Soil and Rock as Used in Engineering Design and Construction

    D4220 Practices for Preserving and Transporting Soil Samples

    D4633 Test Method for Energy Measurement for Dynamic Penetrometers

    D5434 Guide for Field Logging of Subsurface Explorations of Soil and Rock

    D5783 Guide for Use of Direct Rotary Drilling with Water-Based Drilling Fluid for Geoenvironmental Exploration and the Installation of Subsurface Water-Quality Monitoring Devices

    D6026 Practice for Using Significant Digits in Geotechnical Data

    D6066 Practice for Determining the Normalized Penetration Resistance of Sands for Evaluation of Liquefaction Potential

    D6151 Practice for Using Hollow-Stem Augers for Geotechnical Exploration and Soil Sampling

    D6169 Guide for Selection of Soil and Rock Sampling Devices Used With Drill Rigs for Environmental Investigations

    D6286 Guide for Selection of Drilling Methods for Environmental Site Characterization

    D6913 Test Methods for Particle-Size Distribution (Gradation) of Soils Using Sieve Analysis


    ICS Code

    ICS Number Code 93.020 (Earth works. Excavations. Foundation construction. Underground works)

    UNSPSC Code

    UNSPSC Code 11111501(Soil); 41113821(Soil penetration tester)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D1586-99

    Citation Format

    ASTM D1586-99, Standard Test Method for Penetration Test and Split-Barrel Sampling of Soils, ASTM International, West Conshohocken, PA, 1999, www.astm.org

    Back to Top