ASTM D1476-02

    Standard Test Method for Heptane Miscibility of Lacquer Solvents



    There is no PDF download available at this time, however you may purchase a copy of this document from the IHS Standards Store
    (Click here to view IHS phone and email contact details).



    1. Scope

    1.1 This test method covers determination of the miscibility of lacquer solvents with heptane. It may also be used to detect qualitatively the presence of moisture in esters and ketones.

    Note 1—For the quantitative determination of water content, see Test Method D 1364.

    1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    1.3 For hazard information and guidance, see the supplier's Material Safety Data Sheet.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D611 Test Methods for Aniline Point and Mixed Aniline Point of Petroleum Products and Hydrocarbon Solvents

    D1364 Test Method for Water in Volatile Solvents (Karl Fischer Reagent Titration Method)


    ICS Code

    ICS Number Code 87.060.30 (Solvents)

    UNSPSC Code

    UNSPSC Code 31211703(Lacquers)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D1476-02

    Citation Format

    ASTM D1476-02, Standard Test Method for Heptane Miscibility of Lacquer Solvents, ASTM International, West Conshohocken, PA, 2002, www.astm.org

    Back to Top