ASTM D140/D140M-09

    Standard Practice for Sampling Bituminous Materials


      Format Pages Price  
    PDF 6 $60.00   ADD TO CART


    1. Scope

    1.1 This practice applies to the sampling of bituminous materials at points of manufacture, storage, or delivery.

    1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D8 Terminology Relating to Materials for Roads and Pavements

    D346 Practice for Collection and Preparation of Coke Samples for Laboratory Analysis


    ICS Code

    ICS Number Code 75.140 (Waxes, bituminous materials and other petroleum products)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D0140_D0140M-09

    Citation Format

    ASTM D140 / D140M-09, Standard Practice for Sampling Bituminous Materials, ASTM International, West Conshohocken, PA, 2009, www.astm.org

    Back to Top