ASTM D1370-00(2007)

    Standard Test Method for Contact Compatibility Between Asphaltic Materials (Oliensis Test)


      Format Pages Price  
    PDF 2 $52.00   ADD TO CART


    1. Scope

    1.1 This test method provides a means for evaluating contact compatibility between asphaltic materials. It is generally used to determine compatibility between the saturant and coating used in the manufacture of prepared roofings. Coating and saturant will be referred to, but comparable asphaltic materials may be tested where this test procedure seems applicable.

    1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves


    ICS Code

    ICS Number Code 91.100.50 (Binders. Sealing materials)

    UNSPSC Code

    UNSPSC Code 30121601(Asphalt)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D1370-00R07

    Citation Format

    ASTM D1370-00(2007), Standard Test Method for Contact Compatibility Between Asphaltic Materials (Oliensis Test), ASTM International, West Conshohocken, PA, 2007, www.astm.org

    Back to Top