ASTM D1301-91(1999)

    Standard Test Methods for Chemical Analysis of White Lead Pigments


      Format Pages Price  
    PDF 5 $60.00   ADD TO CART


    1. Scope

    1.1 These test methods cover procedures for the chemical analysis of basic carbonate white lead and basic sulfate white lead.

    Note 1-If it is necessary to separate these pigments from others, refer to Methods D215.

    1.2 The analytical procedures appear in the following order:

    Section Preparation of Sample 6 Basic Carbonate White Lead: Small Amounts of Iron 7 Total Lead 8 Moisture and Other Volatile Matter 9 Carbon Dioxide (Evolution Method) 10 Carbon Dioxide and Combined Water (Combustion 11 Method) Lead Carbonate 12 Total Matter Insoluble in Acetic Acid 13 Total Matter Insoluble in Acid Ammonium Acetate 14 Total Impurities Other Than Moisture 15 Coarse Particles 16 Basic Sulfate White Lead: Small Amounts of Iron 17 Total Lead 18 Moisture and Other Volatile Matter 19 Total Sulfate 20 Zinc Oxide 21 Basic Lead Oxide 22 Total Impurities 23 Coarse Particles 24

    1.3 This standard does not purport to address the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.>


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    C25 Test Methods for Chemical Analysis of Limestone, Quicklime, and Hydrated Lime

    D185 Test Methods for Coarse Particles in Pigments

    D215 Practice for the Chemical Analysis of White Linseed Oil Paints

    D280 Test Methods for Hygroscopic Moisture (and Other Matter Volatile Under the Test Conditions) in Pigments

    D1193 Specification for Reagent Water

    D2371 Test Method for Pigment Content of Solvent-Reducible Paints

    D2372 Practice for Separation of Vehicle From Solvent-Reducible Paints

    D3280 Test Methods for Analysis of White Zinc Pigments

    E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves


    ICS Code

    ICS Number Code 87.060.10 (Pigments and extenders)

    UNSPSC Code

    UNSPSC Code 31211503(Pigment paints)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D1301-91R99

    Citation Format

    ASTM D1301-91(1999), Standard Test Methods for Chemical Analysis of White Lead Pigments, ASTM International, West Conshohocken, PA, 1999, www.astm.org

    Back to Top