ASTM D1267-95

    Standard Test Method for Gage Vapor Pressure of Liquefied Petroleum (LP) Gases (LP-Gas Method)


      Format Pages Price  
    PDF 5 $60.00   ADD TO CART


    1. Scope

    1.1 This test method covers the determination of the gage vapor pressures of liquefied petroleum gas products at temperatures of 37.8°C (100°F) up to and including a test temperature of 70°C (158°F).

    1.2 The values stated in acceptable metric units are to be regarded as the standard. The values in parentheses are for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see 3.2.1 and Annex A2.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D323 Test Method for Vapor Pressure of Petroleum Products (Reid Method)

    D1265 Practice for Sampling Liquefied Petroleum (LP) Gases, Manual Method

    D6897 Test Method for Vapor Pressure of Liquefied Petroleum Gases (LPG) (Expansion Method)


    UNSPSC Code

    UNSPSC Code 15111510(Liquified petroleum gas)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D1267-95

    Citation Format

    ASTM D1267-95, Standard Test Method for Gage Vapor Pressure of Liquefied Petroleum (LP) Gases (LP-Gas Method), ASTM International, West Conshohocken, PA, 2002, www.astm.org

    Back to Top