SUPERSEDED (click for Active standard)
  | Format | Pages | Price |   |
![]() |
3 | $52.00 | ![]() |
1. Scope
1.1 This test method covers the determination of the freezing point of an aqueous engine coolant solution in the laboratory.
Note 1— Where solutions of specific concentrations are to be tested, they shall be prepared from representative samples as directed in Practice D 1176. Secondary phases separating on dilution need not be separated.
Note 2—These products may also be marketed in a ready-to-use form (prediluted).
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D1176 Practice for Sampling and Preparing Aqueous Solutions of Engine Coolants or Antirusts for Testing Purposes
E1 Specification for ASTM Liquid-in-Glass Thermometers
ICS Code
ICS Number Code 71.100.45 (Refrigerants and antifreezes)
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/D1177-07
Citation Format
ASTM D1177-07, Standard Test Method for Freezing Point of Aqueous Engine Coolants, ASTM International, West Conshohocken, PA, 2007, www.astm.org
Back to Top