ASTM D1148-07

    Standard Test Method for Rubber Deterioration—Discoloration from Ultraviolet (UV) and Heat Exposure of Light-Colored Surfaces


      Format Pages Price  
    PDF 4 $52.00   ADD TO CART


    1. Scope

    1.1 This test method covers techniques to evaluate the surface discoloration of white or light-colored vulcanized rubber that may occur when subjected to UV or UV/visible exposure from specified sources under controlled conditions of relative humidity, or moisture, and temperature.

    1.2 This test method also describes how to qualitatively evaluate the degree of discoloration produced under such conditions.

    1.3 The term "discoloration" applies to a color change of the rubber sample, as distinguished from staining (see Note 1), that refers to a color change of a metal finish in contact with or adjacent to the rubber specimen.

    1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    Note 1—Tests for staining are covered by Test Methods D 925.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D925 Test Methods for Rubber Property--Staining of Surfaces (Contact, Migration, and Diffusion)

    D2244 Practice for Calculation of Color Tolerances and Color Differences from Instrumentally Measured Color Coordinates

    D3182 Practice for RubberMaterials, Equipment, and Procedures for Mixing Standard Compounds and Preparing Standard Vulcanized Sheets

    D3183 Practice for RubberPreparation of Pieces for Test Purposes from Products

    G151 Practice for Exposing Nonmetallic Materials in Accelerated Test Devices that Use Laboratory Light Sources

    G154 Practice for Operating Fluorescent Ultraviolet (UV) Lamp Apparatus for Exposure of Nonmetallic Materials

    G155 Practice for Operating Xenon Arc Light Apparatus for Exposure of Non-Metallic Materials


    ICS Code

    ICS Number Code 83.060 (Rubber)

    UNSPSC Code

    UNSPSC Code 13100000(Rubber and elastomers)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D1148-07

    Citation Format

    ASTM D1148-07, Standard Test Method for Rubber Deterioration—Discoloration from Ultraviolet (UV) and Heat Exposure of Light-Colored Surfaces, ASTM International, West Conshohocken, PA, 2007, www.astm.org

    Back to Top