ASTM D1146-00(2007)

    Standard Test Method for Blocking Point of Potentially Adhesive Layers


      Format Pages Price  
    PDF 2 $52.00   ADD TO CART


    1. Scope

    1.1 This test method covers the determination of the blocking point of a thermoplastic or a hygroscopic layer or coating of potentially adhesive material. Potentially adhesive materials comprise those materials in a substantially nonadhesive state which may be activated to an adhesive state by application of heat or solvents.

    1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D907 Terminology of Adhesives


    ICS Code

    ICS Number Code 83.180 (Adhesives)

    UNSPSC Code

    UNSPSC Code 31201600(Other adhesives and sealants)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D1146-00R07

    Citation Format

    ASTM D1146-00(2007), Standard Test Method for Blocking Point of Potentially Adhesive Layers, ASTM International, West Conshohocken, PA, 2007, www.astm.org

    Back to Top