ASTM D1101-97a(2006)

    Standard Test Methods for Integrity of Adhesive Joints in Structural Laminated Wood Products for Exterior Use


      Format Pages Price  
    PDF 3 $52.00   ADD TO CART


    1. Scope

    1.1 These test methods cover an accelerated means of measuring the resistance to delamination of structural laminated wood members intended for exterior service.

    1.2 These test methods are not intended as substitutes or replacements for the more severe test of resistance to delamination in Specification D 2559, which is used to qualify adhesives for structural laminated wood products for use under exterior (wet-use) exposure conditions under industry standard ANSI/AITC A190.1-1992.

    1.3 Two test methods are included. Choice of test method depends on purpose of the test and available time to complete.

    1.3.1 Test Method A This test requires 3 days to complete and is a method for determining the suitability of adhesives and manufacturing techniques and equipment for production of joints adequate for exterior service.

    1.3.2 Test Method B This test requires approximately 121/2 h. (If excessive delamination occurs, the cycle is repeated). It is a quality-control type test for examining adhesive joint quality.

    1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D907 Terminology of Adhesives

    D2559 Specification for Adhesives for Bonded Structural Wood Products for Use Under Exterior Exposure Conditions

    Other Standards

    ANSI A190.1 American Nation Standard for Wood ProductsStructural Glued Laminated Timber


    ICS Code

    ICS Number Code 83.180 (Adhesives)

    UNSPSC Code

    UNSPSC Code 31200000(Adhesives and sealants); 11121600(Wood)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D1101-97AR06

    Citation Format

    ASTM D1101-97a(2006), Standard Test Methods for Integrity of Adhesive Joints in Structural Laminated Wood Products for Exterior Use, ASTM International, West Conshohocken, PA, 2006, www.astm.org

    Back to Top