ASTM D1015-05(2010)

    Standard Test Method for Freezing Points of High-Purity Hydrocarbons

      Format Pages Price  
    PDF 9 $60.00   ADD TO CART

    1. Scope

    1.1 This test method covers a procedure for the precise measurement of the freezing points of high-purity hydrocarbons.

    1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see 5.1, 6.1 and 6.2.

    Note 1—For the calculation of the molal purity of essentially pure compounds from measured freezing points and for procedures to be used for the sampling and determination of purity of certain specific compounds, see Test Method D1016.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1016 Test Method for Purity of Hydrocarbons from Freezing Points

    D1265 Practice for Sampling Liquefied Petroleum (LP) Gases, Manual Method

    D4057 Practice for Manual Sampling of Petroleum and Petroleum Products

    ICS Code

    ICS Number Code 71.080.01 (Organic chemicals in general)

    UNSPSC Code

    UNSPSC Code

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/D1015-05R10

    Citation Format

    ASTM D1015-05(2010), Standard Test Method for Freezing Points of High-Purity Hydrocarbons, ASTM International, West Conshohocken, PA, 2010,

    Back to Top