SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|3||$50.00||  ADD TO CART|
1.1 This specification covers preformed rubber gaskets used to seal joints in cast iron soil pipe and fittings.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 The following safety hazards caveat pertains only to the test methods section of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 The committee with jurisdiction over this standard is not aware of another comparable standard for materials covered in this standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A644 Terminology Relating to Iron Castings
C1277 Specification for Shielded Couplings Joining Hubless Cast Iron Soil Pipe and Fittings
D395 Test Methods for Rubber Property--Compression Set
D412 Test Methods for Vulcanized Rubber and Thermoplastic Elastomers--Tension
D471 Test Method for Rubber Property--Effect of Liquids
D573 Test Method for Rubber--Deterioration in an Air Oven
D624 Test Method for Tear Strength of Conventional Vulcanized Rubber and Thermoplastic Elastomers
D1149 Test Methods for Rubber Deterioration--Cracking in an Ozone Controlled Environment
D1415 Test Method for Rubber Property--International Hardness
D2240 Test Method for Rubber Property--Durometer Hardness
D3677 Test Methods for Rubber--Identification by Infrared Spectrophotometry
Other DocumentsCISPI 310 Specification for couplings for use in connection with hubless cast iron soil pipe and fittings for sanitary and storm drain, waste, and vent piping applications Available from Cast Iron Soil Pipe Institute (CISPI), http://www.cispi.org. RMA Class 3 Dimensional Tolerances, RMA Manual Available from Association for Rubber Products Manufacturers (ARPM), 7321 Shadeland Station Way, Suite 285, Indianapolis, IN 46256, http://www.arpminc.org.
ICS Number Code 23.040.80 (Seals for pipe and hose assemblies)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM C564-03, Standard Specification for Rubber Gaskets for Cast Iron Soil Pipe and Fittings, ASTM International, West Conshohocken, PA, 2003, www.astm.orgBack to Top