ASTM C29/C29M-07

    Standard Test Method for Bulk Density (Unit Weight) and Voids in Aggregate


      Format Pages Price  
    PDF 5 $55.20   ADD TO CART

    Active (view current version of standard)

    Translated Standard: Spanish

    Other Historical Standards

    Work Item(s) - proposed revisions of this standard

    ASTM License Agreement

    More C09.20 Standards Related Products


    1. Scope

    1.1 This test method covers the determination of bulk density ("unit weight") of aggregate in a compacted or loose condition, and calculated voids between particles in fine, coarse, or mixed aggregates based on the same determination. This test method is applicable to aggregates not exceeding 125 mm [5 in.] in nominal maximum size.

    Note 1 - Unit weight is the traditional terminology used to describe the property determined by this test method, which is weight per unit volume (more correctly, mass per unit volume or density).

    1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard, as appropriate for a specification with which this test method is used. An exception is with regard to sieve sizes and nominal size of aggregate, in which the SI values are the standard as stated in Specification E 11. Within the text, inch-pound units are shown in brackets. The values stated in each system may not be exact equivalents; therefore each system must be used independently of the other, without combining values in any way.

    This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    C125 Terminology Relating to Concrete and Concrete Aggregates

    C127 Test Method for Relative Density (Specific Gravity) and Absorption of Coarse Aggregate

    C128 Test Method for Relative Density (Specific Gravity) and Absorption of Fine Aggregate

    C670 Practice for Preparing Precision and Bias Statements for Test Methods for Construction Materials

    C702/C702M Practice for Reducing Samples of Aggregate to Testing Size

    C1077 Practice for Agencies Testing Concrete and Concrete Aggregates for Use in Construction and Criteria for Testing Agency Evaluation

    D75/D75M Practice for Sampling Aggregates

    E11 Specification for Woven Wire Test Sieve Cloth and Test Sieves


    UNSPSC Code

    UNSPSC Code 30111800(Aggregates)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/C0029_C0029M-07

    Citation Format

    ASTM C29 / C29M-07, Standard Test Method for Bulk Density (Unit Weight) and Voids in Aggregate, ASTM International, West Conshohocken, PA, 2007, www.astm.org

    Back to Top