Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM C285-88(2005)

Standard Test Methods for Sieve Analysis of Wet-Milled and Dry-Milled Porcelain Enamel

Standard Test Methods for Sieve Analysis of Wet-Milled and Dry-Milled Porcelain Enamel C0285-88R05 ASTM|C0285-88R05|en-US Standard Test Methods for Sieve Analysis of Wet-Milled and Dry-Milled Porcelain Enamel Standard new BOS Vol. 02.05 Committee B08
$ 66.00 In stock

Significance and Use

The fineness of the frit has a direct bearing on many of its properties, such as fusibility, tearing, gloss, opacity, suspension in the slip, and ease of spraying.

Scope

1.1 These test methods cover the determination of the fineness of frit in wet- or dry-milled porcelain enamels and other ceramic coatings for metals by means of the No. 200 (75-m) or No. 325 (45-m) sieve.

1.2 The two methods appear as follows:

Sections
Method A-Referee MethodMethod B-Routine Method4 to 910 to 14

1.3 Method A is intended for use where a referee method of higher accuracy is required, while Method B is intended to meet the needs of normal enamel plant production control operations where a rapid, simplified method of sieve testing is required. The accuracy of the simplified method has proved to be entirely adequate for this use. The simplified test, however, is not recommended where high accuracy is required.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 02.05
Developed by Subcommittee: B08.12
Pages: 3
DOI: 10.1520/C0285-88R05
ICS Code: 25.220.50