SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|12||$69.00||  ADD TO CART|
1.1 This specification covers the evaluating of the performance of heavy duty shielded couplings to join hubless cast iron soil pipe and fittings.
1.2 Couplings covered by this standard shall have minimum dimensions as found in Table 1 and Fig. 1 of this standard.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 The committee with jurisdiction over this standard is aware of comparable standards published by other organizations, namely Cast Iron Soil Pipe Institute specification CISPI 310 and Factory Mutual Research standard FM 1680.
1.5 The following precautionary caveat pertains only to the test method portion, Section 7, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
|Nominal Pipe Size||Coupling Width|
|1½ to 4 in. (38 to 100 mm)||3 in. (76 mm) Minimum Width|
|5 to 10 in. (127 to 254 mm)||4 in. (100 mm) Minimum Width|
|12 to 15 in. (305 to 381 mm)||5½ in. (140 mm) Minimum Width|
FIG. 1 Typical Center Stop Detail
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A240/A240M Specification for Chromium and Chromium-Nickel Stainless Steel Plate, Sheet, and Strip for Pressure Vessels and for General Applications
A493 Specification for Stainless Steel Wire and Wire Rods for Cold Heading and Cold Forging
A644 Terminology Relating to Iron Castings
A888 Specification for Hubless Cast Iron Soil Pipe and Fittings for Sanitary and Storm Drain, Waste, and Vent Piping Applications
C564 Specification for Rubber Gaskets for Cast Iron Soil Pipe and Fittings
D3677 Test Methods for RubberIdentification by Infrared Spectrophotometry
CISPI StandardsCISPI 301 Specification for Hubless Cast Iron Soil Pipe and Fittings for Sanitary and Storm Drain, Waste and Vent Piping Applications CISPI 310 Specification for Couplings for Use in Connection with Hubless Cast Iron Soil Pipe and Fittings for Sanitary and Storm Drain, Waste, and Vent Piping Applications
Factory Mutual StandardFM 1680 Approval Standard for Couplings Used in Hubless Cast Iron Systems for Drain, Waste or Vent, Sewer, Rainwater, or Storm Drain Systems Above and Below Ground, Industrial/Commercial and Residential
ICS Number Code 23.040.60 (Flanges, couplings and joints)
UNSPSC Code 40172603(Cast iron pipe coupling)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM C1540-09a, Standard Specification for Heavy Duty Shielded Couplings Joining Hubless Cast Iron Soil Pipe and Fittings, ASTM International, West Conshohocken, PA, 2009, www.astm.orgBack to Top