ASTM C1435-99

    Standard Practice for Molding Roller-Compacted Concrete in Cylinder Molds Using a Vibrating Hammer


      Format Pages Price  
    PDF 3 $50.00   ADD TO CART


    1. Scope

    1.1 This practice covers molding cylindrical test specimens from concrete when the standard procedures of rodding and internal vibration, as described in Practice C31/C31M and Practice C 1176, are not practicable. This practice is applicable to freshly-mixed concrete, prepared in the laboratory and the field.

    1.2 Freshly-mixed concrete is molded in cylindrical molds using an electric vibrating hammer equipped with a shaft and circular plate.

    1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the inch-pound units are shown in brackets. The values stated in each system may not be exact equivalents, therefore, each system must be used independently of each other without combining in any way.

    1.4 The text of this practice references notes and footnotes, which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered requirements of this practice.

    1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section 6 for additional precautionary information.


    ICS Code

    ICS Number Code 91.100.30 (Concrete and concrete products)

    UNSPSC Code

    UNSPSC Code 30111500(Concrete and mortars)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/C1435-99

    Citation Format

    ASTM C1435-99, Standard Practice for Molding Roller-Compacted Concrete in Cylinder Molds Using a Vibrating Hammer, ASTM International, West Conshohocken, PA, 1999, www.astm.org

    Back to Top