SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|3||$56.00||  ADD TO CART|
1.1 This specification covers the optical and aesthetic quality requirements for coatings applied to glass for use in building glazing.
1.2 The coatings covered are applied to the glass using either pyrolytic or vacuum (sputtering) deposition methods and are typically applied to control solar heat gain, energy performance, comfort level, and condensation and enhance the aesthetic of the building.
1.3 This specification addresses blemishes related to the coating only. It does not address glass blemishes, applied ceramic frits, and organic films.
1.4 Dimensional values are stated in inch-pound units and are to be regarded as the standard units for this specification. The metric units given in parentheses are for information only.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
C162 Terminology of Glass and Glass Products
C1036 Specification for Flat Glass
C1048 Specification for Heat-Strengthened and Fully Tempered Flat Glass
D2244 Practice for Calculation of Color Tolerances and Color Differences from Instrumentally Measured Color Coordinates
ICS Number Code 81.040.20 (Glass in building)
UNSPSC Code 30171700(Glass products)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM C1376-97, Standard Specification for Pyrolytic and Vacuum Deposition Coatings on Glass, ASTM International, West Conshohocken, PA, 1997, www.astm.orgBack to Top