Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM C1339-02

Standard Test Method for Flowability and Bearing Area of Chemical-Resistant Polymer Machinery Grouts

Standard Test Method for Flowability and Bearing Area of Chemical-Resistant Polymer Machinery Grouts C1339-02 ASTM|C1339-02|en-US Standard Test Method for Flowability and Bearing Area of Chemical-Resistant Polymer Machinery Grouts Standard new BOS Vol. 04.02 Committee C09
$ 75.00 In stock

Scope

1.1 This test method covers the measure of flowability of chemical-resistant polymer machinery grouts as evaluated in a 2-in. (5-cm) or 1-in. (2.5-cm) pour thickness. The test method provides for the assessment of upper surface plate contact area (bearing area). These grouts will typically be two- or three-component formulations that may be used for installations where grout thickness will range from 1 to 6 in. (2.5 to 15 cm) underneath the base or plates being grouted.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are for information only.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.02
Developed by Subcommittee: C09.41
Pages: 5
DOI: 10.1520/C1339-02
ICS Code: 83.020