ASTM C1328-05

    Standard Specification for Plastic (Stucco) Cement


      Format Pages Price  
    PDF 4 $54.00   ADD TO CART


    1. Scope

    1.1 This specification covers two types of plastic cement for use in portland cement-based plasters for exterior (stucco) and interior application.

    1.2 The values stated in SI units are to be regarded as the standard. Values in SI units shall be obtained by measurement in SI units or by appropriate conversion, using the Rules for Conversion and Rounding given in IEEE/ASTM SI 10, of measurements made in other units.

    1.3 The text of this standard refers to notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

    1.4 The following safety hazards caveat pertains only to Sections 14 and 15. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (Warning—Fresh hydraulic cementitious mixtures are caustic and may cause chemical burns to skin and tissue upon prolonged exposure.)


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    C109/C109M Test Method for Compressive Strength of Hydraulic Cement Mortars (Using 2-in. or [50-mm] Cube Specimens)

    C151 Test Method for Autoclave Expansion of Hydraulic Cement

    C183 Practice for Sampling and the Amount of Testing of Hydraulic Cement

    C185 Test Method for Air Content of Hydraulic Cement Mortar

    C187 Test Method for Normal Consistency of Hydraulic Cement

    C188 Test Method for Density of Hydraulic Cement

    C219 Terminology Relating to Hydraulic Cement

    C266 Test Method for Time of Setting of Hydraulic-Cement Paste by Gillmore Needles

    C305 Practice for Mechanical Mixing of Hydraulic Cement Pastes and Mortars of Plastic Consistency

    C430 Test Method for Fineness of Hydraulic Cement by the 45-m (No. 325) Sieve

    C511 Specification for Mixing Rooms, Moist Cabinets, Moist Rooms, and Water Storage Tanks Used in the Testing of Hydraulic Cements and Concretes

    C778 Specification for Standard Sand

    C926 Specification for Application of Portland Cement-Based Plaster

    C1506 Test Method for Water Retention of Hydraulic Cement-Based Mortars and Plasters


    ICS Code

    ICS Number Code 91.100.10 (Cement. Gypsum. Lime. Mortar)

    UNSPSC Code

    UNSPSC Code 30111601(Cement)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/C1328-05

    Citation Format

    ASTM C1328-05, Standard Specification for Plastic (Stucco) Cement, ASTM International, West Conshohocken, PA, 2005, www.astm.org

    Back to Top