Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM C1149-06e1

Standard Specification for Self-Supported Spray Applied Cellulosic Thermal Insulation

Standard Specification for Self-Supported Spray Applied Cellulosic Thermal Insulation C1149-06E01 ASTM|C1149-06E01|en-US Standard Specification for Self-Supported Spray Applied Cellulosic Thermal Insulation Standard new BOS Vol. 04.06 Committee C16
$ 75.00 In stock

Abstract

This specification covers self-supported spray applied cellulosic thermal insulation for use as thermal insulation or acoustical absorbent material, or both. The chemically-treated cellulosic materials that are also covered in this specification are used for pneumatic applications operating within a specific temperature range. The materials are classified into two types based on the type of adhesive used and exposure of the application. Specimens for testing should be prepared and tested using the prescribed methods and should conform to the specified values of density, thermal resistance, surface bonding characteristics, adhesive strength, cohesive strength, smoldering combustion, fungi resistance, corrosion, moisture vapor absorption, odor, flame resistance permanency, substrate deflection, and air erosion.

Scope

1.1 The specification covers the physical properties of self-supported spray applied cellulosic fibers intended for use as thermal insulation or an acoustical absorbent material, or both.

1.2 This specification covers chemically treated cellulosic materials intended for pneumatic applications where temperatures do not exceed 82.2°C (180°F) and where temperatures will routinely remain below 65.6°C (150°F).

1.2.1 Type I—Material applied with liquid adhesive and suitable for either exposed or enclosed applications.

1.2.2 Type II—Materials containing a dry adhesive that is activated by water during installation and intended only for enclosed or covered applications.

1.3 This is a material specification only and is not intended to deal with methods of application that are supplied by the manufacturer.

1.4 The values stated in SI units are to be regarded as standard. The inch-pound units given in parentheses are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.06
Developed by Subcommittee: C16.23
Pages: 8
DOI: 10.1520/C1149-06E01
ICS Code: 91.120.10