SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|4||$48.00||  ADD TO CART|
1.1 This specification establishes the requirements for copper-zinc-tin-bismuth alloy rod, bar and wire of alloy UNS No. C49300 intended for use in plumbing applications and drinking water systems.
1.2 Typically, rod and bar product made to this specification is furnished as straight lengths. Wire (H04) 0.08-0.3 in. [2-8 mm inclusive] is furnished in coil form.
1.3 The following safety hazard caveat pertains only to the test method(s) described in this specification.
1.3.1 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.5 A Japanese patent application has been submitted for UNS Alloy C49300. A patent application is being prepared for review by the U.S. Patent Office. An international patent application has been submitted to PCT (Patent Cooperation Treaty). Alternative materials will be included in this document when they become available.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B249/B249M Specification for General Requirements for Wrought Copper and Copper-Alloy Rod, Bar, Shapes and Forgings
B250/B250M Specification for General Requirements for Wrought Copper Alloy Wire
B846 Terminology for Copper and Copper Alloys
E8/E8M Test Methods for Tension Testing of Metallic Materials
E54 Test Methods for Chemical Analysis of Special Brasses and Bronzes
E62 Test Methods for Chemical Analysis of Copper and Copper Alloys (Photometric Methods)
E92 Test Method for Vickers Hardness of Metallic Materials
E478 Test Methods for Chemical Analysis of Copper Alloys
Other StandardsJIS H 1068:2005 Method for Determination of Bismuth in Copper and Copper Alloys Japanese Industrial Standard, available through http://www.JIS.or.jp/
ICS Number Code 77.150.30 (Copper products)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM B967 / B967M-09, Standard Specification for Copper-Zinc-Tin-Bismuth Alloy Rod, Bar and Wire, ASTM International, West Conshohocken, PA, 2009, www.astm.orgBack to Top