SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|3||$48.00||  ADD TO CART|
1.1 This specification covers zinc alloys in ingot form for remelting for the manufacture of Spin Castings as specified and designated, as shown in Table 1. Seven alloy compositions are specified, designated as follows:
|Spin Casting Alloy SC-A||...||...|
|Spin Casting Alloy SC-B||...||...|
|Spin Casting Alloy SC-C||...||...|
|Spin Casting Alloy SC-D||HJ10||...|
|Spin Casting Alloy SC-E||HJ20||...|
|Spin Casting Alloy SC-F||HJ40||...|
1.2 Zinc alloys #2, #3, #5, and ZA-8 specified in Specification B240 are also used in the spin casting process.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.
TABLE 1 Chemical and North American Color Code Requirements
|Alloy SC-A||Alloy SC-B||Alloy SC-C||ZA-73||Alloy SC-D||Alloy SC-E||Alloy SC-F|
|Nickel, max||...||...||0.02||...||. . .||0.02||. . .|
A Per Practice B908.
B For purposes of acceptance and rejection, the observed value or calculated value obtained from analysis should be rounded to the nearest unit in the last right-hand place of figures, used in expressing the specific limit in accordance with the rounding procedure prescribed in Practice E29.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B240 Specification for Zinc and Zinc-Aluminum (ZA) Alloys in Ingot Form for Foundry and Die Castings
B899 Terminology Relating to Non-ferrous Metals and Alloys
B908 Practice for the Use of Color Codes for Zinc Casting Alloy Ingot
B949 Specification for General Requirements for Zinc and Zinc Alloy Products
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
E88 Practice for Sampling Nonferrous Metals and Alloys in Cast Form for Determination of Chemical Composition
E536 Test Methods for Chemical Analysis of Zinc and Zinc Alloys
E634 Practice for Sampling of Zinc and Zinc Alloys by Spark Atomic Emission Spectrometry
ISO StandardsISO 3815-1 Zinc and zinc alloys--Part 1: Analysis of solid samples by optical emission spectrometry ISO 3815-2 Zinc and zinc alloys--Part 2: Analysis by inductively coupled plasma optical emission
ICS Number Code 77.150.60 (Lead, zinc and tin products)
UNSPSC Code 30262900(Zinc ingots strips billets and coil)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM B952 / B952M-12, Standard Specification for Zinc Alloys in Ingot Form for Spin Casting, ASTM International, West Conshohocken, PA, 2012, www.astm.orgBack to Top