SUPERSEDED (click for Active standard)
  | Format | Pages | Price |   |
![]() |
3 | $54.00 | ![]() |
Active (view current version of standard)
Work Item(s) - proposed revisions of this standard
1. Scope
1.1 This test method covers measuring the surface finish of powder metallurgy (P/M) products at all stages of manufacturing from green compact to fully hardened finished component.
1.2 This test method provides the definition and schematic of some common surface finish parameters (R
1.3 &inch-pound-units;
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
MPIF Standard
MPIF Standard 58 Method for Determination of Surface Finish of Powder Metallurgy ProductsICS Code
ICS Number Code 25.220.40 (Metallic coatings); 77.160 (Powder metallurgy)
UNSPSC Code
UNSPSC Code
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/B0946-06
Citation Format
ASTM B946-06, Standard Test Method for Surface Finish of Powder Metallurgy (P/M) Products, ASTM International, West Conshohocken, PA, 2006, www.astm.org
Back to Top