Products and Services / Standards & Publications / Standards Products


    ASTM B919-01(2006)

    Standard Specification for Welded Copper Heat Exchanger Tubes With Internal Enhancement

    SUPERSEDED (click for Active standard)

      Format Pages Price  
    PDF 7 $62.00   ADD TO CART

    Reprints and Permissions

    Permissions to reprint documents can be acquired through
    Copyright Clearance Center   Visit Copyright Clearance Center  

    Reprints and Permissions

    Permissions to reprint documents can be acquired through
    Copyright Clearance Center  

    Visit Copyright Clearance Center  

    Reprints and Permissions

    Permissions to reprint documents can be acquired through
    Copyright Clearance Center  

    Visit Copyright Clearance Center  

    Active (view current version of standard)

    Other Historical Standards

    ASTM License Agreement

    More B05.04 Standards Related Products

    1. Scope

    1.1 This specification establishes the requirements for welded, internally enhanced copper tube, in straight lengths or coils, suitable for use in refrigeration and air conditioning products or other heat exchangers.

    1.2 Units The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered standard.

    1.3 The product shall be produced of the following coppers. Unless otherwise specified, tubes made from any one of these coppers may be supplied:

    Copper UNS No.Type of Metal
    C10200Oxygen-free without residual deoxidants
    C12200Phosphorized, high residual phosphorus (DHP)

    The following pertains to the test method described in of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B153 Test Method for Expansion (Pin Test) of Copper and Copper-Alloy Pipe and Tubing

    B577 Test Methods for Detection of Cuprous Oxide (Hydrogen Embrittlement Susceptibility) in Copper

    B601 Classification for Temper Designations for Copper and Copper AlloysWrought and Cast

    B846 Terminology for Copper and Copper Alloys

    E3 Guide for Preparation of Metallographic Specimens

    E8/E8M Test Methods for Tension Testing of Metallic Materials

    E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

    E62 Test Methods for Chemical Analysis of Copper and Copper Alloys (Photometric Methods)

    E112 Test Methods for Determining Average Grain Size

    E243 Practice for Electromagnetic (Eddy Current) Examination of Copper and Copper-Alloy Tubes

    E255 Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition

    E478 Test Methods for Chemical Analysis of Copper Alloys

    E2575 Standard Test Method for Determination of Oxygen in Copper and Copper Alloys

    ICS Code

    ICS Number Code 77.140.30 (Steels for pressure purposes)

    UNSPSC Code

    UNSPSC Code 40181500(Welded copper tubes); 40101802(Heat exchangers)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/B0919-01R06

    Citation Format

    ASTM B919-01(2006), Standard Specification for Welded Copper Heat Exchanger Tubes With Internal Enhancement, ASTM International, West Conshohocken, PA, 2006, www.astm.org

    Back to Top