SUPERSEDED (click for Active standard)
  | Format | Pages | Price |   |
![]() |
4 | $54.00 | ![]() |
Active (view current version of standard)
1. Scope
1.1 This specification covers bare round copper-clad steel for the following applications: electrical, electronic, grounding, telecommunications, and other applications.
1.2 Four conductivities are covered as follows: 21, 30, 40, and 70 %.
1.3 Temper is designated as annealed.
1.4 The values stated in inch-pound or SI units are to be regarded separately as the standard. Each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. For conductor sizes designated by AWG, the requirements in SI units have been numerically converted from corresponding values stated or derived in inch-pound units. For conductor sizes designated by SI units only, the requirements are stated or derived in SI units.
1.5 The following precautionary statement pertains to the test method portion only, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
NIST Document
NBS Handbook 100 Copper Wire TablesASTM Standards
B193 Test Method for Resistivity of Electrical Conductor Materials
B258 Specification for Standard Nominal Diameters and Cross-Sectional Areas of AWG Sizes of Solid Round Wires Used as Electrical Conductors
ICS Code
ICS Number Code 77.140.65 (Steel wire, wir ropes and link chains)
UNSPSC Code
UNSPSC Code 26121520(Copper steel wire)
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/B0910_B0910M-00
Citation Format
ASTM B910 / B910M-00, Standard Specification for Annealed Copper-Clad Steel Wire, ASTM International, West Conshohocken, PA, 2000, www.astm.org
Back to Top