ASTM B90/B90M-98(2005)

    Standard Specification for Magnesium-Alloy Sheet and Plate


      Format Pages Price  
    PDF 8 $54.00   ADD TO CART


    1. Scope

    1.1 This specification covers magnesium alloys in sheet and plate form designated as shown in .

    1.2 The values stated in either inch-pound or SI units are to be regarded separately as standards. The SI units are shown in brackets or in separate tables or columns. The values stated in each system are not exact equivalents; therefore, each system must be used independent of the other. Combining values from the two systems may result in nonconformance with the specification.

    1.3 Unless the order specifies the "M" specification designation, the material shall be furnished to the inch-pound units.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B557 Test Methods for Tension Testing Wrought and Cast Aluminum- and Magnesium-Alloy Products

    B557M Test Methods for Tension Testing Wrought and Cast Aluminum- and Magnesium-Alloy Products (Metric)

    B660 Practices for Packaging/Packing of Aluminum and Magnesium Products

    B954 Test Method for Analysis of Magnesium and Magnesium Alloys by Atomic Emission Spectrometry

    E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

    E55 Practice for Sampling Wrought Nonferrous Metals and Alloys for Determination of Chemical Composition

    Federal Standards

    Fed. Std. No. 123 Marking for Shipment (Civil Agencies)

    Fed. Std. No. 184 Identification Marking of Aluminum, Magnesium and Titanium

    Military Standards

    MIL-STD-129 Marking for Shipment and Storage


    ICS Code

    ICS Number Code 77.150.20 (Magnesium products)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/B0090_B0090M-98R05

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM B90 / B90M-98(2005), Standard Specification for Magnesium-Alloy Sheet and Plate, ASTM International, West Conshohocken, PA, 2005, www.astm.org

    Back to Top