ASTM B869-07(2013)

    Standard Specification for Copper-Clad Steel Electrical Conductor for CATV Drop Wire


      Format Pages Price  
    PDF 3 $54.00   ADD TO CART


    1. Scope

    1.1 This specification covers 21 % conductivity hard-drawn round copper-clad steel wire for coaxial cable center conductors (Note 1).

    Note 1Wire ordered to this specification is not intended for redrawing since it is furnished in the hard-drawn temper. If wire is desired for the purpose, the manufacturer should be consulted.

    1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    NIST Document

    NBS Handbook 100 Copper Wire Tables

    ASTM Standards

    B193 Test Method for Resistivity of Electrical Conductor Materials

    B258 Specification for Standard Nominal Diameters and Cross-Sectional Areas of AWG Sizes of Solid Round Wires Used as Electrical Conductors


    ICS Code

    ICS Number Code 29.060.10 (Wires)

    UNSPSC Code

    UNSPSC Code 26121520(Copper steel wire)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/B0869-07R13

    Citation Format

    ASTM B869-07(2013), Standard Specification for Copper-Clad Steel Electrical Conductor for CATV Drop Wire, ASTM International, West Conshohocken, PA, 2013, www.astm.org

    Back to Top