ASTM B833-00

    Standard Specification for Zinc and Zinc Alloy Wire for Thermal Spraying (Metallizing)

      Format Pages Price  
    PDF 4 $49.20   ADD TO CART

    1. Scope

    1.1 This specification covers zinc and zinc alloy wire used in depositing zinc coatings by thermal spraying (metallizing). Zinc and zinc alloy wire provided under this specification is intended for use in oxy-fuel and electric arc thermal protection of iron and steel. Additional zinc alloy compositions used in thermal spraying primarily for electronic applications are found in Specification B907.

    1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Data Sheet for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ISO Standards

    ISO 3815-1 Zinc and zinc alloys -- Part 1: Analysis of solid samples by optical emission spectrometry

    ISO 3815-2 Zinc and zinc alloys -- Part 2: Analysis by inductively coupled plasma optical emission spectrometry

    ASTM Standards

    B6 Specification for Zinc

    B899 Terminology Relating to Non-ferrous Metals and Alloys

    B907 Specification for Zinc, Tin and Cadmium Base Alloys Used as Solders

    B943 Specification for Zinc and Tin Alloy Wire Used in Thermal Spraying for Electronic Applications

    E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

    E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)

    E536 Test Methods for Chemical Analysis of Zinc and Zinc Alloys

    ANSI/AWS Standard

    ANSI/AWS A5.33 Specification for Solid and Ceramic Wires and Ceramic Rods for Thermal Spraying

    ICS Code

    ICS Number Code 25.220.20 (Surface treatment)

    UNSPSC Code

    UNSPSC Code 11101704(Steel)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/B0833-00

    Citation Format

    ASTM B833-00, Standard Specification for Zinc and Zinc Alloy Wire for Thermal Spraying (Metallizing), ASTM International, West Conshohocken, PA, 2001,

    Back to Top