SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|7||$62.00||  ADD TO CART|
1.1 This specification establishes the requirements for seamless round, rectangular, and square copper tube suitable for general engineering applications.
1.1.1 Tubes made from any of the following Copper UNS No. designations shall be supplied unless otherwise specified in the contract or purchase order:
|Copper UNS No.||Type of Copper|
|C10200||Oxygen-free without residual deoxidants|
|C10300||Oxygen-free, extra low phosphorus|
|C10800||Oxygen-free, low phosphorus|
|C12000||Phosphorus deoxidized, low residual phosphorus|
|C12200||Phosphorus deoxidized, high residual phosphorus|
1.2 The values stated in inch-pound units are the standard except for grain size values which are given in SI units.
1.3 This specification is the companion to SI Specification B 75M; therefore no SI equivalents are presented in this specification.
1.4 The following hazard statement pertains only to the test method described in Sections 184.108.40.206, 21.2.9, and 21.2.10 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B75M Specification for Seamless Copper Tube (Metric)
B153 Test Method for Expansion (Pin Test) of Copper and Copper-Alloy Pipe and Tubing
B170 Specification for Oxygen-Free Electrolytic Copper--Refinery Shapes
B193 Test Method for Resistivity of Electrical Conductor Materials
B251 Specification for General Requirements for Wrought Seamless Copper and Copper-Alloy Tube
B577 Test Methods for Detection of Cuprous Oxide (Hydrogen Embrittlement Susceptibility) in Copper
B601 Classification for Temper Designations for Copper and Copper Alloys--Wrought and Cast
E3 Guide for Preparation of Metallographic Specimens
E8 Test Methods for Tension Testing of Metallic Materials
E18 Test Methods for Rockwell Hardness of Metallic Materials
E53 Test Method for Determination of Copper in Unalloyed Copper by Gravimetry
E62 Test Methods for Chemical Analysis of Copper and Copper Alloys (Photometric Methods)
E112 Test Methods for Determining Average Grain Size
E243 Practice for Electromagnetic (Eddy-Current) Examination of Copper and Copper-Alloy Tubes
E255 Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition
E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
ICS Number Code 77.150.30 (Copper products)
UNSPSC Code 40182000(Seamless copper tubes)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM B75-02, Standard Specification for Seamless Copper Tube, ASTM International, West Conshohocken, PA, 2002, www.astm.orgBack to Top