ASTM B697-88(2005)

    Standard Guide for Selection of Sampling Plans for Inspection of Electrodeposited Metallic and Inorganic Coatings

      Format Pages Price  
    PDF 8 $62.00   ADD TO CART

    1. Scope

    1.1 This guide gives guidance in the selection of sampling plans to be used in the inspection of electrodeposited and related coatings on products for the purpose of deciding whether submitted lots of coated products comply with the specifications applicable to the coatings. This supplements Test Method B 602 by giving more information on sampling inspection and by providing additional sampling plans for the user who finds the limited choice of plans in Test Method B 602 to be inadequate.

    1.2 When using a sampling plan, a relatively small part of the articles in an inspection lot is selected and inspected. Based on the results, a decision is made that the inspection lot either does or does not satisfactorily conform to the specification.

    1.3 This guide also contains several sampling plans. The plans are attribute plans, that is, in the application of the plans each inspected article is classified as either conforming or nonconforming to each of the coating requirements. The number of nonconforming articles is compared to a maximum allowable number. The plans are simple and relatively few. Additional plans and more complex plans that cover more situations are given in the Refs (1-7) at the end of this guide and in MIL-STD 105.

    1.4 Acceptance sampling plans are used:

    1.4.1 When the cost of inspection is high and the consequences of accepting a nonconforming article are not serious.

    1.4.2 When 100 % inspection is fatiguing and boring and, therefore, likely to result in errors. In these cases a sampling plan may provide greater protection than 100 % inspection.

    1.4.3 When inspection requires a destructive test. Here, sampling inspection must be used.

    1.5 Another general type of acceptance sampling plan that is not covered in these guidelines is the variables plan in which measured values of characteristics are analyzed by statistical procedures. Such plans, when applicable, can reduce inspection cost and increase quality protection. Information on variables plans is given in Test Method B 762, MIL-STD-414, ANSI/ASQC Z1.9-1979, and Refs (1-2).

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    Military Standards


    MIL-STD-414 Sampling Procedures and Tables for Inspection by Variables for Percent Defective

    ASTM Standards

    B602 Test Method for Attribute Sampling of Metallic and Inorganic Coatings

    B762 Test Method of Variables Sampling of Metallic and Inorganic Coatings

    ICS Code

    ICS Number Code 25.220.40 (Metallic coatings)

    UNSPSC Code

    UNSPSC Code

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/B0697-88R05

    Citation Format

    ASTM B697-88(2005), Standard Guide for Selection of Sampling Plans for Inspection of Electrodeposited Metallic and Inorganic Coatings, ASTM International, West Conshohocken, PA, 2005,

    Back to Top