SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|2||$48.00||  ADD TO CART|
1.1 This test method covers the determination of abrasive wear resistance of cemented carbides.
1.2 The values stated in inch-pound units are to be regarded as the standard. The SI equivalents of inch-pound units are in parentheses and may be approximate.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B311 Test Method for Density of Powder Metallurgy (PM) Materials Containing Less Than Two Percent Porosity
G40 Terminology Relating to Wear and Erosion
G65 Test Method for Measuring Abrasion Using the Dry Sand/Rubber Wheel Apparatus
G75 Test Method for Determination of Slurry Abrasivity (Miller Number) and Slurry Abrasion Response of Materials (SAR Number)
G105 Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests
ICS Number Code 77.160 (Powder metallurgy)
UNSPSC Code 31133700(Powdered metals and metal alloys)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM B611-85(2005), Standard Test Method for Abrasive Wear Resistance of Cemented Carbides, ASTM International, West Conshohocken, PA, 2005, www.astm.orgBack to Top