ASTM B602-88(2005)

    Standard Test Method for Attribute Sampling of Metallic and Inorganic Coatings

      Format Pages Price  
    PDF 6 $62.00   ADD TO CART

    1. Scope

    1.1 This test method gives sampling plans that are intended for use in the inspection of metallic and inorganic coatings for conformance to ASTM standard specifications.

    1.2 The plans in this test method, except as noted, have been selected from some of the single sampling plans of MIL-STD-105D. The specific plans selected are identified in Tables 1-3 of this test method. The plan of Table 4, which is used for destructive testing, is not from the Military Standard. This standard does not contain the Military Standard's requirement for tightened inspection when the quality history of a supplier is unsatisfactory.

    1.3 The plans are based on inspection by attributes, that is, an article of product is inspected and is classified as either conforming to a requirement placed on it, or as nonconforming. Sampling plans based on inspection by variables are given in Test Method B 762. Variables plans are applicable when a test yields a numerical value for a characteristic, when the specification imposes a numerical limit on the characteristic, and when certain statistical criteria are met. These are explained in Test Method B 762.

    1.4 The plans in this test method are intended to be generally suitable. There may be instances in which tighter or looser plans or ones that are more discriminating are desired. Additional plans that may serve these needs are given in Guide B 697. Also, Guide B 697 describes the nature of attribute sampling plans and the several factors that must be considered in the selection of a sampling plan. More information and an even greater selection of plans are given in MIL-STD-105D, MIL-STD-414, ANSI/ASQC Z1.9, Refs (1-7), and in Guide B 697.

    1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    Military Standards


    MIL-STD-414 Sampling Procedures and Tables for Inspection by Variables for Percent Defective

    ASTM Standards

    B697 Guide for Selection of Sampling Plans for Inspection of Electrodeposited Metallic and Inorganic Coatings

    B762 Test Method of Variables Sampling of Metallic and Inorganic Coatings

    ICS Code

    ICS Number Code 25.220.40 (Metallic coatings); 25.220.99 (Other treatments and coatings)

    UNSPSC Code

    UNSPSC Code

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/B0602-88R05

    Citation Format

    ASTM B602-88(2005), Standard Test Method for Attribute Sampling of Metallic and Inorganic Coatings, ASTM International, West Conshohocken, PA, 2005,

    Back to Top