SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|4||$54.00||  ADD TO CART|
1.1 These test methods describe procedures for determining the presence of cuprous oxide (Cu2O) in products made from deoxidized and oxygen-free copper.
1.2 The test methods appear in the following order:
Microscopical Examination without Thermal Treatment
Microscopical Examination after Thermal Treatment
Closed Bend Test after Thermal Treatment
Reverse Bend Test after Thermal Treatment
1.3 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
E3 Guide for Preparation of Metallographic Specimens
E883 Guide for ReflectedLight Photomicrography
ICS Number Code 77.120.30 (Copper and copper alloys)
UNSPSC Code 11101711(Non ferrous alloy)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM B577-16, Standard Test Methods for Detection of Cuprous Oxide (Hydrogen Embrittlement Susceptibility) in Copper, ASTM International, West Conshohocken, PA, 2016, www.astm.orgBack to Top