ASTM B566-93(1998)e1

    Standard Specification for Copper-Clad Aluminum Wire

    There is no PDF download available at this time, however you may purchase a copy of this document from the IHS Standards Store
    (Click here to view IHS phone and email contact details).

    1. Scope

    1.1 This specification covers bare round copper-clad aluminum wire for electrical applications.

    1.2 Four classes of copper-clad aluminum wire are covered as follows: Class 10A-Nominal 10 volume % copper, annealed. Class 15A-Nominal 15 volume % copper, annealed. Class 10H-Nominal 10 volume % copper, hard-drawn. Class 15H-Nominal 15 volume % copper, hard-drawn.

    1.3 The values stated in inch-pound units are to be regarded as the standard, except for resistivity and density, where the SI units are the standard. The values given in parentheses are for information only.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B193 Test Method for Resistivity of Electrical Conductor Materials

    B258 Specification for Nominal Diameters and Cross-Sectional Areas of AWG Sizes of Solid Round Wires Used as Electrical Conductors

    National Institute of Standards and Technology

    NBS Handbook 100 Copper Wire Tables

    UNSPSC Code

    UNSPSC Code 26121519(Copper clad aluminum wire)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/B0566-93R98E01

    Citation Format

    ASTM B566-93(1998)e1, Standard Specification for Copper-Clad Aluminum Wire, ASTM International, West Conshohocken, PA, 1998,

    Back to Top