SUPERSEDED (click for Active standard)
  | Format | Pages | Price |   |
![]() |
5 | $62.00 | ![]() |
Active (view current version of standard)
1. Scope
1.1 This guide covers the use of the dropping test to measure the thickness of electrodeposited zinc, cadmium, copper, and tin coatings. Note 1Under most circumstances this method of measuring coating thicknesses is not as reliable or as convenient to use as an appropriate coating thickness gauge (see Test Methods B 499, B 504, and B 568).
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
B487 Test Method for Measurement of Metal and Oxide Coating Thickness by Microscopical Examination of Cross Section
B499 Test Method for Measurement of Coating Thicknesses by the Magnetic Method: Nonmagnetic Coatings on Magnetic Basis Metals
B504 Test Method for Measurement of Thickness of Metallic Coatings by the Coulometric Method
B568 Test Method for Measurement of Coating Thickness by X-Ray Spectrometry
D1193 Specification for Reagent Water
ICS Code
ICS Number Code 25.220.40 (Metallic coatings)
UNSPSC Code
UNSPSC Code
Link Here | |||
Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/B0555-86R07
Citation Format
ASTM B555-86(2007), Standard Guide for Measurement of Electrodeposited Metallic Coating Thicknesses by Dropping Test, ASTM International, West Conshohocken, PA, 2007, www.astm.org
Back to Top