ASTM B457-67(2013)

    Standard Test Method for Measurement of Impedance of Anodic Coatings on Aluminum

      Format Pages Price  
    PDF 3 $54.00   ADD TO CART

    1. Scope

    1.1 This test method describes the conditions and equipment for measuring the impedance of anodic coatings on aluminum. Such measurements have been used to evaluate the quality of seal of an anodic coating. The test method does not prescribe the procedure for producing the anodic coating, nor the postanodizing treatment usually described as “sealing.”

    1.2 This test method is applicable to the rapid, nondestructive testing of anodic coatings. The interpretation of results and correlation of data with service experience and other tests are not within the scope of this test method.

    1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    ICS Code

    ICS Number Code 25.220.20 (Surface treatment)

    UNSPSC Code

    UNSPSC Code 11101705(Aluminum)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/B0457-67R13

    Citation Format

    ASTM B457-67(2013), Standard Test Method for Measurement of Impedance of Anodic Coatings on Aluminum, ASTM International, West Conshohocken, PA, 2013,

    Back to Top