SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|9||$54.00||  ADD TO CART|
1.1 This specification establishes the requirements for welded copper tube with a longitudinal seam free of filler metal produced from sheet or strip of the following coppers:
|Copper UNS Nos.||Type of Copper|
|C10300||Oxygen-free, extra low phosphorus|
|C10800||Oxygen-free, low phosphorus|
|C11000||Electrolytic tough pitch|
|C12000||Phosphorus deoxidized, low residual phosphorus|
|C12200||Phosphorus deoxidized, high residual phosphorus|
|C14200||Phosphorus deoxidized, arsenical|
1.2 Unless otherwise specified in the contract or purchase order, product furnished of any listed copper, with the exception of copper C11000, shall be considered acceptable.
1.2.1 Copper C11000 welded tube shall not be used in applications in which heating may cause hydrogen embrittlement.
1.3 Values stated in inch-pound units are the standard except for grain size which is given in SI units. Values given in parentheses are for information only.
1.4 The following hazard caveat pertains only to Section 15 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B153 Test Method for Expansion (Pin Test) of Copper and Copper-Alloy Pipe and Tubing
B170 Specification for Oxygen-Free Electrolytic Copper--Refinery Shapes
B193 Test Method for Resistivity of Electrical Conductor Materials
B577 Test Methods for Detection of Cuprous Oxide (Hydrogen Embrittlement Susceptibility) in Copper
B601 Classification for Temper Designations for Copper and Copper Alloys--Wrought and Cast
B846 Terminology for Copper and Copper Alloys
E3 Guide for Preparation of Metallographic Specimens
E8/E8M Test Methods for Tension Testing of Metallic Materials
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
E53 Test Method for Determination of Copper in Unalloyed Copper by Gravimetry
E62 Test Methods for Chemical Analysis of Copper and Copper Alloys (Photometric Methods)
E112 Test Methods for Determining Average Grain Size
E243 Practice for Electromagnetic (Eddy-Current) Examination of Copper and Copper-Alloy Tubes
E255 Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition
E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
ICS Number Code 23.040.15 (Non-ferrous metal pipes); 77.150.30 (Copper products)
UNSPSC Code 40181500(Welded copper tubes)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM B447-02, Standard Specification for Welded Copper Tube, ASTM International, West Conshohocken, PA, 2002, www.astm.orgBack to Top