Products and Services / Standards & Publications / Standards Products


    ASTM B37-08(2013)

    Standard Specification for Aluminum for Use in Iron and Steel Manufacture

    SUPERSEDED (click for Active standard)

      Format Pages Price  
    PDF 3 $54.00   ADD TO CART

    Reprints and Permissions

    Permissions to reprint documents can be acquired through
    Copyright Clearance Center   Visit Copyright Clearance Center  

    Reprints and Permissions

    Permissions to reprint documents can be acquired through
    Copyright Clearance Center  

    Visit Copyright Clearance Center  

    Reprints and Permissions

    Permissions to reprint documents can be acquired through
    Copyright Clearance Center  

    Visit Copyright Clearance Center  

    Active (view current version of standard)

    Other Historical Standards

    ASTM License Agreement

    More B07.01 Standards Related Products

    1. Scope

    1.1 This specification covers aluminum and aluminum alloys in the form of ingots, bars, rods, cones, nuggets or shot, designated as shown in Table 1, for use in the manufacture of iron and steel.

    1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B660 Practices for Packaging/Packing of Aluminum and Magnesium Products

    B666/B666M Practice for Identification Marking of Aluminum and Magnesium Products

    B881 Terminology Relating to Aluminum- and Magnesium-Alloy Products

    D3951 Practice for Commercial Packaging

    E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

    E34 Test Methods for Chemical Analysis of Aluminum and Aluminum-Base Alloys

    E607 Test Method for Atomic Emission Spectrometric Analysis Aluminum Alloys by the Point to Plane Technique Nitrogen Atmosphere

    E716 Practices for Sampling and Sample Preparation of Aluminum and Aluminum Alloys for Determination of Chemical Composition by Spark Atomic Emission Spectrometry

    E1251 Test Method for Analysis of Aluminum and Aluminum Alloys by Spark Atomic Emission Spectrometry

    ICS Code

    ICS Number Code 77.120.10 (Aluminium and aluminium alloys)

    UNSPSC Code

    UNSPSC Code 11101705(Aluminum)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/B0037-08R13

    Citation Format

    ASTM B37-08(2013), Standard Specification for Aluminum for Use in Iron and Steel Manufacture, ASTM International, West Conshohocken, PA, 2013, www.astm.org

    Back to Top