Standard Historical Last Updated: Jun 07, 2018 Track Document
ASTM B26/B26M-14e1

Standard Specification for Aluminum-Alloy Sand Castings

Standard Specification for Aluminum-Alloy Sand Castings B0026_B0026M-14E01 ASTM|B0026_B0026M-14E01|en-US Standard Specification for Aluminum-Alloy Sand Castings Standard new BOS Vol. 02.02 Committee B07
$ 83.00 In stock

Abstract

This specification covers aluminum alloy sand castings except those that are for aerospace applications. The chemical compositions are determined in accordance with the specified suitable chemical and spectrochemical test methods. Addition of small amounts of modifiers and grain refining elements to the molten alloys from the remelting furnace is permitted before casting. Pure metals, recycled materials, and master alloys can also be used to make the alloys as long as the chemical composition can be analyzed and adjusted to conform to the requirements prior to pouring any casting. Castings should only be repaired using approved processes such as welding, impregnation, peening, blending, soldering, and so forth.

Scope

1.1 This specification2 covers aluminum-alloy sand castings designated as shown in Table 1.

(A) Contains silver 0.40–1.0 %.
(B) If iron exceeds 0.45 %, manganese content shall not be less than one half of the iron content.
(C) Contains beryllium 0.003–0.007 %, boron 0.005 % max.
(D) 710.0 formerly A712.0, 712.0 formerly D712.0, 851.0 formerly A850.0, 852.0 formerly B850.0.
(E) ASTM alloy designations are recorded in Practice B275.
(F) “Others” includes listed elements for which no specific limit is shown as well as unlisted metallic elements. The producer may analyze samples for trace elements not specified in the specification. However, such analysis is not required and may not cover all metallic “Others” elements. Should any analysis by the producer or the purchaser establish that an “Others” element exceeds the limit of “Each” or that the aggregate of several “Others” elements exceeds the limit of “Total,” the material shall be considered nonconforming.
(G) Other Elements–Total shall be the sum of unspecified metallic elements 0.010 % or more, rounded to the second decimal before determining the sum.

1.2 This specification is for aluminum-alloy sand castings used in general purpose applications. It may not address the mechanical properties, integrity testing, and verification required for highly loaded or safety critical applications.

1.3 Alloy and temper designations are in accordance with ANSI H35.1/H35.1M. Unified Numbering System alloy designations are in accordance with Practice E527.

1.4 Unless the order specifies the “M” specification designation, the material shall be furnished to the inch-pound units.

1.5 For acceptance criteria for inclusion of new aluminum and aluminum alloys and their properties in this specification, see Annex A1 and Annex A2.

1.6 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 02.02
Developed by Subcommittee: B07.01
Pages: 14
DOI: 10.1520/B0026_B0026M-14E01
ICS Code: 77.150.10