SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|3||$48.00||  ADD TO CART|
1.1 This specification covers commercial zinc and zinc-aluminum (ZA) alloys in ingot form for remelting for the manufacture of pressure die castings and foundry castings as designated and specified in Table 1. Seven alloy compositions are specified, designated as follows:
|Z33521||AG 40A||Alloy 3|
|Z33522||AG 40B||Alloy 7|
|Z35530||AC 41A||Alloy 5|
|Z35540||AC 43A||Alloy 2|
1.2 Zinc alloys Z33521, Z33522, Z35530, and Z35540 are used primarily for remelting in the manufacture of pressure die castings. Zinc-aluminum alloys Z35635, Z35630, and Z35840 are used for remelting in the manufacture of both foundry and pressure die castings. Castings made from these ingots are specified in ASTM B86, Standard Specification for Zinc and Zinc-Aluminum Alloys for Foundry and Die Castings.
1.3 The values stated in inch-pound units are to be regarded as standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Data Sheet for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B86 Specification for Zinc and Zinc-Aluminum (ZA) Alloy Foundry and Die Castings
B275 Practice for Codification of Certain Nonferrous Metals and Alloys, Cast and Wrought
B897 Specification for Configuration of Zinc and Zinc Alloy Jumbo Block and Half Block Ingot
B899 Terminology Relating to Non-ferrous Metals and Alloys
B908 Practice for the Use of Color Codes for Zinc Casting Alloy Ingot
B949 Specification for General Requirements for Zinc and Zinc Alloy Products
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
E536 Test Methods for Chemical Analysis of Zinc and Zinc Alloys
ISO StandardsISO 301 Zinc Alloy Ingots Intended for Casting ISO 3815–1 Zinc and zinc alloys -- Part 1: Analysis of solid samples by optical emission spectrometry. ISO 3815–2 Zinc and zinc alloys -- Part 2: Analysis by inductively coupled plasma optical emission spectrometry.
ICS Number Code 77.150.60 (Lead, zinc and tin products)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM B240-98e1, Standard Specification for Zinc and Zinc-Aluminum (ZA) Alloys in Ingot Form for Foundry and Die Castings, ASTM International, West Conshohocken, PA, 2001, www.astm.orgBack to Top