ASTM B189-95
Standard Specification for Lead-Coated and Lead-Alloy-Coated Soft Copper Wire for Electrical Purposes (Withdrawn 2004)
SUPERSEDED (click for Active standard)
| Format | Pages | Price | ||
 |
6 | $62.00 |  ADD TO CART |
Active (view current version of standard)
1. Scope
1.1 This specification covers lead-coated and lead-alloy-coated, round, soft or annealed copper wire for electrical purposes.
1.2 The SI values for density and resistivity are to be regarded as the standard. For all other properties the inch-pound values are to be regarded as the standard and the SI units may be approximate.
1.3 The hazard statement applies only to Section 6, Test Methods of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
B49 Specification for Copper Rod Drawing Stock for Electrical Purposes
B193 Test Method for Resistivity of Electrical Conductor Materials
B258 Specification for Nominal Diameters and Cross-Sectional Areas of AWG Sizes of Solid Round Wires Used as Electrical Conductors
NIST
NBS Handbook 100 Copper Wire Tables Available from National Institute of Standards and Technology (NIST), 100 Bureau Dr., Stop 1070, Gaithersburg, MD 20899-1070, http://www.nist.gov.ICS Code
ICS Number Code 29.060.10 (Wires)
UNSPSC Code
UNSPSC Code 26121517(Copper wire)
Referencing This Standard
| Link Here | |||
| Link to Active (This link will always route to the current Active version of the standard.) | |||
DOI: 10.1520/B0189-95
Citation Format
ASTM B189-95, Standard Specification for Lead-Coated and Lead-Alloy-Coated Soft Copper Wire for Electrical Purposes (Withdrawn 2004), ASTM International, West Conshohocken, PA, 1995, www.astm.org
Back to Top