ASTM B183-79(1997)

    Standard Practice for Preparation of Low-Carbon Steel for Electroplating

      Format Pages Price  
    PDF 3 $49.20   ADD TO CART

    1. Scope

    1.1 This practice is intended as an aid to electroplaters in setting up a suitable cleaning cycle preparatory to electroplating of low-carbon steel (Note 1) containing less than 0.35 mass% of carbon and to indicate some of the precautions that must be taken to maintain this cycle in good operating condition.

    Note 1-The preparation of high-carbon steel for electroplating is covered in Practice B242.

    1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B242 Guide for Preparation of High-Carbon Steel for Electroplating

    B322 Guide for Cleaning Metals Prior to Electroplating

    ICS Code

    ICS Number Code 25.220.10 (Surface preparation)

    UNSPSC Code

    UNSPSC Code

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/B0183-79R97

    Citation Format

    ASTM B183-79(1997), Standard Practice for Preparation of Low-Carbon Steel for Electroplating, ASTM International, West Conshohocken, PA, 1997,

    Back to Top