SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|7||$62.00||  ADD TO CART|
1.1 This specification covers commercial aluminum alloys in ingot form for remelting and molten form for the manufacture of castings. The specific gravity of these alloys does not exceed 3.0 and they are designated as shown in Tables 1 and 2.
Note 1- Throughout this specification the use of "ingot" in a general sense includes sow, T-bar, T-ingot, and pig.
1.2 Alloy designations are in accordance with ANSI H35.1. The equivalent Unified Numbering System alloy designations are in accordance with Practice E 527.
Note 2- Supplementary data pertaining to the alloys covered by this specification when used in the form of castings are given in Specifications B 26/B 26M, B 85, B 108, B 618, and B 686.
1.3 For acceptance criteria for inclusion of new aluminum and aluminum alloys in this specification, see Annex A1.
1.4 The values stated in inch-pound units are to be regarded as the standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B26/B26M Specification for Aluminum-Alloy Sand Castings
B85/B85M Specification for Aluminum-Alloy Die Castings
B108/B108M Specification for Aluminum-Alloy Permanent Mold Castings
B618/B618M Specification for Aluminum-Alloy Investment Castings
B666/B666M Practice for Identification Marking of Aluminum and Magnesium Products
B686/B686M Specification for Aluminum Alloy Castings, High-Strength
B955/B955M Specification for Aluminum-Alloy Centrifugal Castings
B969/B969M Specification for Aluminum-Alloy Castings Produced by Squeeze Casting, Thixocast and Rheocast Semi-Solid Casting Processes
B985 Practice for Sampling Aluminum Ingots, Billets, Castings and Finished or Semi-Finished Wrought Aluminum Products for Compositional Analysis
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
E34 Test Methods for Chemical Analysis of Aluminum and Aluminum-Base Alloys
E607 Test Method for Atomic Emission Spectrometric Analysis Aluminum Alloys by the Point to Plane Technique Nitrogen Atmosphere
E716 Practices for Sampling and Sample Preparation of Aluminum and Aluminum Alloys for Determination of Chemical Composition by Spark Atomic Emission Spectrometry
E1251 Test Method for Analysis of Aluminum and Aluminum Alloys by Spark Atomic Emission Spectrometry
ANSI StandardH35.1/H35.1(M) American National Standard Alloy and Temper Designation Systems for Aluminum Available from Aluminum Association, Inc., 1400 Crystal Drive Suite 430 Arlington, VA 22202 http://www.aluminum.org.
ICS Number Code 77.150.10 (Aluminium products)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM B179-96, Standard Specification for Aluminum Alloys in Ingot and Molten Forms for Castings from All Casting Processes, ASTM International, West Conshohocken, PA, 1996, www.astm.orgBack to Top